/usr/share/doc/hddtemp/README is in hddtemp 0.3-beta15-52.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 | DESCRIPTION
===========
hddtemp will show you the hard drive temperature if the hard drive can
(modern drives support this feature).
COPYRIGHT
=========
This software is distributed under the GPL license.
Please see COPYING file.
INSTALLATION
============
Run ./configure (see --help for options), then just type 'make' and don't forget
to get the last hddtemp.db file on the site :
$ wget http://www.guzu.net/linux/hddtemp.db
By default, the hddtemp.db will we searched in /usr/share/misc directory but
you can change this at compilation time with the --with-db-path option:
$ ./configure --with-db-path=/etc/hddtemp.db
INFORMATION
===========
hddtemp accesses to the SATA disks via ATA pass-through commands (defined in
T10/04-262r7). Only kernel >= 2.6.16 have this support.
In daemon mode, hddtemp doesn't allow too much query at a time. If the interval
between two query is inferior to 1 minute, hddtemp will give the previous value
(hddtemp query the disk for each connection, if the period is superior to 1
minute).
After starting hddtemp in daemon mode, you can test it with a simple telnet
or netcat:
$ telnet localhost 7634
or
$ netcat localhost 7634
(note: sometimes the netcat command is called nc).
If you know that your drive has a temperature sensor and is reported to be
unsupported tell me which model and which manufacturer it is, and/or just
add a new entry in hddtemp.db. Each line of hddtemp.db is either a commentary,
a blank line or a line containing:
- a regular expression that allow hddtemp to recognize a drive or a set of drives
from its model name or from a generic model name,
- a value (ATTRIBUTE_ID from S.M.A.R.T.),
- a description.
The separator option allows to specify a separator in the case the drive's name
contains the default separator. Be carefull not to use '?' or '*' which could
exists in the reply of hddtemp.
CONTACT
=======
Emmanuel Varagnat: hddtemp@guzu.net
http://www.guzu.net
|