/usr/share/doc/libjs-mathjax-doc/html/_sources/options/input-processors/AsciiMath.rst.txt is in libjs-mathjax-doc 2.7+20171212-1.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 | .. _configure-AsciiMath:
*****************************
The AsciiMath input processor
*****************************
The options below control the operation of the AsciiMath input
processor that is run when you include ``"input/AsciiMath"`` in the
`jax` array of your configuration or load a combined configuration
file that includes the AsciiMath input jax. They are listed with
their default values. To set any of these options, include a
``AsciiMath`` section in your :meth:`MathJax.Hub.Config()` call. For
example
.. code-block:: javascript
MathJax.Hub.Config({
AsciiMath: {
fixphi: true,
useMathMLspacing: true,
displaystyle: false,
decimalsign: "."
}
});
would set the ``displaystyle`` configuration option so that the limits
for operators like summation symbols will appear next to them rather
than above and below.
.. describe:: fixphi: true
Determines whether MathJax will switch the Unicode values
for ``phi`` and ``varphii``. If set to ``true`` MathJax will
use the TeX mapping, otherwise the Unicode mapping.
.. describe:: useMathMLspacing: true
Determines whether MathJax will use MathML spacing. Set to
``false`` to get TeX-like spacing.
.. describe:: displaystyle: true
Determines whether operators like summation symbols will have
their limits above and below the operators (true) or to their
right (false). The former is how they would appear in displayed
equations that appear on their own lines, while the latter is
better suited to in-line equations so that they don't interfere
with the line spacing so much.
.. describe:: decimalsign: "."
This is the character to be used for decimal points in numbers.
if you change this to ``","``, then you need to be careful about
entering points or intervals. E.g., use ``(1, 2)`` rather than
``(1,2)`` in that case.
|