postinst is in libasedrive-serial 3.7-6.
This file is a maintainer script. It is executed when installing (*inst) or removing (*rm) the package.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 | #! /bin/sh
# postinst script for libasedrive
#
# see: dh_installdeb(1)
set -e
# summary of how this script can be called:
# * <postinst> `configure' <most-recently-configured-version>
# * <old-postinst> `abort-upgrade' <new version>
# * <conflictor's-postinst> `abort-remove' `in-favour' <package>
# <new-version>
# * <deconfigured's-postinst> `abort-deconfigure' `in-favour'
# <failed-install-package> <version> `removing'
# <conflicting-package> <version>
# for details, see http://www.debian.org/doc/debian-policy/ or
# the debian-policy package
#
cfgdir=/etc/reader.conf.d
cfg=$cfgdir/libase_drive
lib=/usr/lib/pcsc/drivers/ifd-ASEDriveIIIe-Serial/libASESerial.so
case "$1" in
configure|reconfigure)
# Source debconf library
. /usr/share/debconf/confmodule
db_get 'libasedrive-serial/port' || true
SERIAL_PORT="$RET"
# Check that cfgdir exists
[ ! -d $cfgdir ] && mkdir -p $cfgdir
# Write config file
rm -f $cfg
echo "# Athena ASEDriveIIIe serial reader" >> $cfg
echo "# see /usr/share/doc/libasedrive-serial/readme" >> $cfg
echo "FRIENDLYNAME \"ASEDriveIIIe Serial Reader\"" >> $cfg
echo "DEVICENAME /dev/$SERIAL_PORT" >> $cfg
echo "LIBPATH $lib" >> $cfg
case "$SERIAL_PORT" in
ttyS0)
echo "CHANNELID 0x0103F8" >> $cfg
;;
ttyS1)
echo "CHANNELID 0x0102F8" >> $cfg
;;
ttyS2)
echo "CHANNELID 0x0103E8" >> $cfg
;;
ttyS3)
echo "CHANNELID 0x0102E8" >> $cfg
;;
None)
rm -f $cfg
;;
*)
echo "Error: unrecognized serial port ($SERIAL_PORT)"
;;
esac
# end debconf
db_stop
;;
abort-upgrade|abort-remove|abort-deconfigure)
;;
*)
echo "postinst called with unknown argument \`$1'" >&2
exit 1
;;
esac
# dh_installdeb will replace this with shell code automatically
# generated by other debhelper scripts.
exit 0
|