/etc/fail2ban/fail2ban.conf is in fail2ban 0.8.11-1.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 | # Fail2Ban main configuration file
#
# Comments: use '#' for comment lines and ';' (following a space) for inline comments
#
# Changes: in most of the cases you should not modify this
# file, but provide customizations in fail2ban.local file, e.g.:
#
# [Definition]
# loglevel = 4
#
[Definition]
# Option: loglevel
# Notes.: Set the log level output.
# 1 = ERROR
# 2 = WARN
# 3 = INFO
# 4 = DEBUG
# Values: [ NUM ] Default: 1
#
loglevel = 3
# Option: logtarget
# Notes.: Set the log target. This could be a file, SYSLOG, STDERR or STDOUT.
# Only one log target can be specified.
# If you change logtarget from the default value and you are
# using logrotate -- also adjust or disable rotation in the
# corresponding configuration file
# (e.g. /etc/logrotate.d/fail2ban on Debian systems)
# Values: [ STDOUT | STDERR | SYSLOG | FILE ] Default: STDERR
#
logtarget = /var/log/fail2ban.log
# Option: socket
# Notes.: Set the socket file. This is used to communicate with the daemon. Do
# not remove this file when Fail2ban runs. It will not be possible to
# communicate with the server afterwards.
# Values: [ FILE ] Default: /var/run/fail2ban/fail2ban.sock
#
socket = /var/run/fail2ban/fail2ban.sock
# Option: pidfile
# Notes.: Set the PID file. This is used to store the process ID of the
# fail2ban server.
# Values: [ FILE ] Default: /var/run/fail2ban/fail2ban.pid
#
pidfile = /var/run/fail2ban/fail2ban.pid
|