/usr/share/openmpi/help-mca-base.txt is in openmpi-common 1.6.5-8.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 | # -*- text -*-
#
# Copyright (c) 2004-2005 The Trustees of Indiana University and Indiana
# University Research and Technology
# Corporation. All rights reserved.
# Copyright (c) 2004-2005 The University of Tennessee and The University
# of Tennessee Research Foundation. All rights
# reserved.
# Copyright (c) 2004-2005 High Performance Computing Center Stuttgart,
# University of Stuttgart. All rights reserved.
# Copyright (c) 2004-2005 The Regents of the University of California.
# All rights reserved.
# Copyright (c) 2008 Cisco Systems, Inc. All rights reserved.
# $COPYRIGHT$
#
# Additional copyrights may follow
#
# $HEADER$
#
# This is the US/English help file for Open MPI MCA error messages.
#
[find-available:none-found]
No available %s components were found!
This means that there are no components of this type installed on your
system or all the components reported that they could not be used.
This is a fatal error; your MPI process is likely to abort. Check the
output of the "ompi_info" command and ensure that components of this
type are available on your system. You may also wish to check the
value of the "component_path" MCA parameter and ensure that it has at
least one directory that contains valid MCA components.
#
[find-available:not-valid]
A requested component was not found, or was unable to be opened. This
means that this component is either not installed or is unable to be
used on your system (e.g., sometimes this means that shared libraries
that the component requires are unable to be found/loaded). Note that
Open MPI stopped checking at the first component that it did not find.
Host: %s
Framework: %s
Component: %s
#
[framework-param:too-many-negates]
MCA framework parameters can only take a single negation operator
("^"), and it must be at the beginning of the value. The following
value violates this rule:
%s
When used, the negation operator sets the "exclusive" behavior mode,
meaning that it will exclude all specified components (and implicitly
include all others). If the negation operator is not specified, the
"inclusive" mode is assumed, meaning that all specified components
will be included (and implicitly exclude all others).
For example, "^a,b" specifies the exclusive behavior and means "use
all components *except* a and b", while "c,d" specifies the inclusive
behavior and means "use *only* components c and d."
You cannot mix inclusive and exclusive behavior.
|